Crank shaft Nut

I need the pulley nut from a the crack shaft with the locking washer, (MGC 6 cylinder) does anyone have one or know were to get one? Its a 1 inch super fine threaded nut.

http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=45222

Ouch!

I think VB has 'em too. Half the price if you trust their quality. Check with Mr. Kirk also.

Hope this helps- Dave

Moss motors does not have them and have not had them for 3 years, I will try Victoria British.
Thanks Tom

Size it and go to a fastener store. [url=http://www.freesmileys.org/smileys.php][/url]

Thanks everyone, Victoria British had one and it's ordered!!
thanks

12B7082 in stock....

VB hardware is always a subject of concern. They are the only folks I know who have sold MG head studs that stretch before torque is achieved. I imagine they've long ago been pulled but....

Yeah, I stopped buying hardware from VB when I ordered bridge bolts for my MGB's calipers, and they sent some ungraded, zinc plated bolts that I probably could have bought at the hardware store much cheaper. The original bolts had a nylock insert running down the length of the thread, and looked to be at least grade 8 (blackened not plated). I can't remember if the originals had grade markings on them.

Anyway, I called VB and voiced my concern that the bridge bolts they were selling may not be high enough grade for the application. I asked what the grade of the bolts were and all I got in reply was a snippy comment "I'm sure we wouldn't sell anything that wasn't safe" and the option to return the bolts for a refund.

That was a long time ago, and I've since stopped buying anything from them because of quality issues (ill fitting water pump was the last straw).

FWIW,
Bill P.