Nov 28, 2009 17:21:13
Thanks to the collective wisdom of this forum, I managed to install the BGT's seats in about 15 minutes. It helped having all original parts, but the two big wins were using the correct cone point fasteners (much easier to thread into a weld nut), and putting temporary screws up from underneath the floor panels to align the rail assemblies. I even installed the single extra-long screw and distance tube to the underside of each inboard seat slide, to prevent the seats from sliding off the front. A little grease on the runners, some never-seize on the screws, and everything works beautifully. If everything goes to plan, the car should be on the road by the end of the year.