TD steering

The MG Experience ~ T-Series & Prewar Forum ~ Archives

Board for the discussion of the MG T-Series and Pre-War MG models (MG TC, MG TD, MG TF, etc)

If you would like to post a reply, please click below to visit the The MG Experience Forums:
T-Series & Prewar Forum: TD steering
http://www.mgexperience.net/phorum/read.php?46,1299291,page=1
Join the discussion, post your photos, or ask your own questions. Membership is FREE!




Dec 06, 2009 06:41:49
Bill Stephens
Click here to Reply

I am rebuilding a previously disassembled TD rack and pinion assembly and I have two questions about the top pinion thrust washer. The first is that it is flat on one side and beveled on the other. Does anyone know which way it goes on? Second, is it a press fit? It appears that you need to set the seal and washer inside the housing and then press the pinion shaft in. The washer doesn't slide by hand to the end of the pinion shaft.

Any advice from someone who has done this would be greatly appreciated. Thanks.

Dec 06, 2009 11:48:26
ddubois
Click here to Reply

Bill - You have a PM.
Cheers,





Dec 07, 2009 06:24:42
Bill Stephens
Click here to Reply

Thanks Dave. That was very helpful.

This is an archived discussion from the The MG Experience Forums

If you would like to post a reply, please click below to visit the The MG Experience Forums:
T-Series & Prewar Forum: TD steering


Archive Index | The MG Experience Forums | Return to The MG Experience