To Mr. Mike's Fiero seat owners...

I'm getting set to install my new seat covers, but i have a question. In the video, Mike says to use the foam pieces, #1,2,&3. I placed them on the seats and sat in them for a while. Now i feel as if the seats are not as comfortable as they were without them. Did you guys use the foam pieces? What about the front of the seat, did it need to be built up under the knee area?

Thanks

Ken

I used the three pieces...they replace the foam that is built into the original upholstry. You can continue to build this up if you wish...easy to add or take away as needed.

You can probably change the pitch of the seat by adapting the seat rails such that the front is higher than the rear.

I didn't change the angle of the seat rails and the seats feel very comfortable. I also used all three pieces of foam. In fact I think the #1 piece of foam is why I didn't have to mess with the rails.

I didn't change the angle of the seat rails and feel very comfortable in the seat. I also used all three pieces of foam. In fact, I think that the #1 piece of foam is why I didn't have to mess with the seat rails.

I used all 3 pieces of foam as well, but changed the angle of the seat when I lowered it. I sat mine a bit lower in the back than before, so I guess its the same as if you padded the front a bit extra.

Thanks guys. I'll go ahead with the foams and try them out in the car before boltinig. Hopefully this weekend.

Ken