FS: GM V6 performance Intake/Carb Parts

I have up for sale almost everything needed for the top end 2.8-3.4L GM V6 conversion (i.e intake, fuel and timing bits). These parts are actually coming off of a different project entirely. Everything is in "like new" condition, except as noted. The intake manifold was installed, but the engine was never fired. Carb was placed on top of manifold to check fit. Parts are as follows:

USED-2.8 Vacuum advance distributor (these are getting harder to find all the time). It has a new ignition module in it. Comes with slightly used cap. Slightly used coil pack. $30 + $5 shipping

Edelbrock 4-barrel intake manifold dual plane conversion for the 2.8-3.4L V6. As noted, this was installed but never run. There was a casting imperfection that needed to be ground down for the lifter valley. There is a new water neck and thermostat installed. The various sensors and what not are installed. The only downside is that I mistakenly used RTV or gasket sealant on the top part of the manifold and it is glued pretty solidly to the bottom. Paid $264 from Summit Racing just for the manifolds. $200 + $5 shipping

Holley 390 cfm 4-barrel carb specifically for this application. Factory refurbished. Fuel filter installed. Electric choke. Comes with 5" chrome air cleaner. $350 new from Summit Racing. I paid about $300 for it. $255 shipped

Edelbrock Chrome valve covers. Sat on car for a long time, never ran, but still a bit dirty. $15 shipped

Various bolts, wires, plugs, vacuum hoses, brackets. Everything that came with these parts should all still be there, including instructions (such as they are). Let me know if you have any questions. As you know, these are some pretty pricey parts when new. I have 100% positive feedback on eBay as gandharvas if you need references. Let me know if you want pictures. I'd prefer selling this all in one package. I paid well over $525 for everything, including shipping, above, but I'd let the whole lot go for $445 shipped. I'd also sell individually at the listed prices. Remember these are not used parts. Buyer installs at own risk, other, minor parts may or may not be required to complete this part of the conversion. PM me to discuss shipping and payment options, etc.