S10 bell housing.

The MG Experience ~ MG Engine Swaps Forum ~ Archives

The Dark Side: V8, V6 & 4 Cylinder Engine Conversions and related radical modifications (brakes, transmission, suspension, drivetrain) for MGB, MGA, Midget and all other MG models. Purists beware!

If you would like to post a reply, please click below to visit the The MG Experience Forums:
MG Engine Swaps Forum: S10 bell housing.
http://www.mgexperience.net/phorum/read.php?40,659424
Join the discussion, post your photos, or ask your own questions. Membership is FREE!

Click here to Reply

I posted on the trader section and am listing here as this may be a better spot. I'm looking for an S10 bellhousing to do a V6 conversion. If someone has one and wishes to sell it, just send me an email. Thanks John

Click here to Reply

A great place to find the bell housing, flywheel and actuator arm is usually car-parts.com I've bought maybe 5 from people listed there and the results have generally been quite good. I usually pay about $50 (plus shipping) for everything.

Click here to Reply

here you go....

http://cgi.ebay.com/ebaymotors/BORG-WARNER-T5-BELL-HOUSING-CLUTCH-FORK-CHEVY-S10-2-8_W0QQitemZ140170898570QQihZ004QQcategoryZ33733QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Straight up version too. (vs the slanted camaro)

Click here to Reply

I've never seen a slanted s10 bell housing from a 2.8 Also, one must use the s10 flywheel. This is great, since it's a lot lighter than the camaro/firebird one, so the engine will rev up much more quickly. At car-parts.com there are 11 pages of flywheels for 2.8 v6's listed, with one full page of them offered for $25. You can pay more for them, if you like... Each page has 20 or 25 listings.

Custom Search

This is an archived discussion from the The MG Experience Forums

If you would like to post a reply, please click below to visit the The MG Experience Forums:
MG Engine Swaps Forum: S10 bell housing.

Archive Index | The MG Experience Forums | Return to The MG Experience