Wanted - Trans crossmember for '62-'67 car

Mine is badly twisted, so I'm looking for a good, straight transmission crossmember for an early 3-synro car.

Thanks.

I think I may have one...If it's the one with the center hole (in the front), and a smaller hole on each side of the center hole...I don't have the bolt-on bracket though...
It is on my car, bolted on by a PO, and I have a proper replacement coming...I will sell you this one for what I am paying for the replacement $50+ shipping...
Let me know...I should have the replacement by the end of the week, and then I can send you this one.
Edward

I'll have to look at mine to see....the steady rod on the early crossmembers bolted on from the rear, so yours could be the later style where the bracket was on the front. I'll dive under my car tomorrow, and take some pics for comparison.

Thanks.

Benny, sent a PM.

Benny
The cross member that I have can turn in either direction...right now, the holes are on the back side...
But you would still need the bracket setup...It is in very good shape, but it's not my year.