WTB HS4 return springs, choke bracket and air cleaners

Anybody have an extra throttle return spring, a choke bracket and a pair of cleaners for an HS4 set up?
thanks
Ray
Rgpracer@cox.net

I do`nt think the HS4s used a choke bracket,the choke cable housing has a L shaped piece that fits over the housing then the inner core is mounted to the heat shield,at least that is the way I rigged Mine up,when You pull out the knob the outer core is drawn downwards opening the enricheners.
I purchased two barrel nuts,slid one over the inner cable then shoved the cable through the small center hole in the bottom of the heatshield then installed another barrel nut on the inner cable below the heat shield,that way pushing or pulling on the cable knob and the inner cable is secure.
I know what I have done is probably not the right way but it works.

HS4 front uses a u-shaped bracket with an arm on it that also serves as the "nuts" for the air cleaner. the arm anchors the choke cable inner. rear u-bracket does not have the arm, and can be replaced with nuts.

HIF is different.

UHHhhh,OK,maby i better start a thread about it and post a couple a pics. of how Mine is jerryrigged.LOL:D tomorrow.