Journal: Bill Greenwood's Journal
|
Visit Bill Greenwood's Profile for more information on this member. Subscribe to this Journal: 
What is RSS?
There are 38 entries in this Journal. Status: Member Location:  OHIO, USA |
|
LH Dog Leg Repair
Created on 2009-11-06 09:47:56
This is a view of the LH dog leg after cutting, clean up & re-welding. Not too many issues here, just needed a good clean out & rust treatment.
Sure be nice if the rear wings were bolt on like the front.
Sure be nice if the rear wings were bolt on like the front.
Click the thumbnail to view image:
Almost complete
Almost complete
Sponsored Links. Did you know you can turn advertising off and support this site by upgrading to a Gold Membership?
Summary of Previous Journal Entries
Showing previous 10 journal entries:
| Title | Date | #Pic | #Cmt | Excerpt |
|---|---|---|---|---|
| Rear Dog Leg 6 | 2009-11-06 | 1 | Sill repair complete with a coat of Epoxy Primer. | |
| Rear Dog Leg 5 | 2009-09-11 | 1 | This is a good shot that shows the inside of the rear sill nicely cleaned up & painted & also shows the triangular shaped filler piece welded in position. | |
| Rear Dog Leg 4 | 2009-09-09 | 1 | This pic shows the repair progressing nicely. | |
| Rear Dog Leg 3 | 2009-09-03 | 1 | I ended up removing the bottom curvature of the door aperture as well, to gain access to do the clean up & welding to the top face of the sill. I also removed the triangular end pi... | |
| Rear Dog Leg 2 | 2009-09-02 | 1 | Each spot weld along the wheel arch & the bottom of the dog leg was carefully drilled out. This pic shows how bad it was underneath. | |
| Rear Dog Leg | 2009-09-01 | 1 | Although both rear dog legs appeared sound, I could feel rust & holes in the top of the sill from the access panel just to the rear of the doors. Ugh! I decided to remove the RH si... | |
| Bulkhead/Master Cylinder Area Repair 4 | 2009-07-08 | 1 | The new outer panel repair section (again scavenged from the donor car) was fit up & welded in place. This fit up was particularly difficult since I had to get behind the ve... | |
| Bulkhead/Master Cylinder Area Repair 3 | 2009-07-07 | 1 | The inner repair panel was welded in first & then protected with weld thru primer. The repair panel was cut out of a donor car. | |
| Bulkhead/Master Cylinder Area Repair 2 | 2009-06-24 | 1 | This pic shows the extent of the damage from inside the engine bay. | |
| Bulkhead/Master Cylinder Area Repair | 2009-06-23 | 1 | After a few weeks break I am back at it once more. This time I am repairing the area adjacent to the master cylinders but the main rot is in the enclosed box sections (again... |
The contents of this journal entry (including entry images) are released
under the terms of the Creative Commons License unless otherwise noted.
under the terms of the Creative Commons License unless otherwise noted.
This page last modified May 09 2009 16:07:49 pm
Add a comment to this journal entry:
Please sign in if you already have an account or register now to enable this feature.