Journal: GILBERT DUPRE's Journal
|
Visit GILBERT (Gil) DUPRE (ret Electrical Engineer)'s Profile for more information on this member. Subscribe to this Journal: There are 80 entries in this Journal. Status: Member Location: |
|
AC From Dash Vents
Created on 2008-06-05 08:40:48
1.Last evening I noticed there was about 1/2 inch space at top of between fan shroud and the top radiator tank. Spread some RTV on tank and on the shroud then took the foam seal that was between the tank and the shroud and stuffed it in between to fill the gap. Ran it up and down freeway this am 85 deg f at about 3000 to 3500 rpm and temp gauge ran just above the normal. So that improved efficiency of the fan shroud. Will check for more gaps around sides then the bottom.
2. Have AC air coming out of center dash vents now temp measures in hose attached to connector on evaporator 2nd from the right measures 46 deg at 3500 rpm and 70 mph outside air is 85 deg temp on freeway probably about 90 and humidity is about 70
2. Have AC air coming out of center dash vents now temp measures in hose attached to connector on evaporator 2nd from the right measures 46 deg at 3500 rpm and 70 mph outside air is 85 deg temp on freeway probably about 90 and humidity is about 70
Sponsored Links. Did you know you can turn advertising off and support this site by upgrading to a Gold Membership?
Summary of Previous Journal Entries
Showing previous 10 journal entries:
| Title | Date | #Pic | #Cmt | Excerpt |
|---|---|---|---|---|
| Dash Air Vent | 2008-06-04 | Today I got my AC hose adaptors for the In Dash vents. The trick was how do you remove the vents. I tried prying out to no avail. Took out glove box to look and feel. Couldnt see a... | ||
| Moss AC Kit In 74.5 | 2008-05-31 | Well I believe I have it cooling as well as can be expected at 1400 rpm low press is about 35 and high is about 175 psi. at 2500 rpm and above low press drops to about 30 and high... | ||
| Audiovox Cruise Control | 2008-04-17 | 1 | I finally connected all the wires that I left hanging from last fall while I installed the Moss AC. Today I took it out and checked the cruise control and man will that be nice thi... | |
| Moss AC Kit In 74.5 | 2008-02-02 | 1 | Finished editing the proceedure I used to get the kit to work in the 74.5 GT. More than 12 hours and more $$$$. Maybe I can trade something for it from Moss hahahaha. | |
| Got It Running | 2008-01-27 | Got the carb fuel leak fixed thanks to Jimmie then found a hose leaking. Got it fixed. started it up and drove around the block was running rough. Lots of dust needs clean... | ||
| Fired Up MGA | 2008-01-14 | After in paint for 2 months I decided to start it up. I have to take it back for color sand and compound. Battery was dead charged for two days no luck. Put on booster battery and ... | ||
| MGA Fender Piping | 2008-01-02 | Got one side of new piping fitted with slots cut for fender mtg bolts. Next re aligning fender to door and body and bolting down. What a job. | ||
| MC Replacement | 2008-01-01 | I completed the MC and Clutch MC replacement and took it for test drive. Clutch works great but I need to maybe bleed brakes again. | ||
| Brakes | 2007-12-30 | Finished brake and clutch MC's replacement. SS brake and clutch hoses and both master cylinders. Replaced fluid with silicone dot 5 fluid. Flushed and bled all lines. | ||
| SS Brake Line | 2007-12-23 | Well today I made more progress. I installed the driver side ss brake line. One day or days I will have to replace the front suspension rubber. It is still there after 33 years. A... |
The contents of this journal entry (including entry images) are released
under the terms of the Creative Commons License unless otherwise noted.
under the terms of the Creative Commons License unless otherwise noted.
This page last modified December 01 2007 20:50:32 pm




Add a comment to this journal entry:
Please sign in if you already have an account or register now to enable this feature.