Journal: Mark W. Jackwood's V8 MGB
 |
Visit Mark W. Jackwood's Profile for more information on this member. Subscribe to this Journal: 
What is RSS?
There are 52 entries in this Journal. Status: Member Location:  Georgia, USA |
|
Disassembly And Paint
Created on 2009-10-29 11:53:24
Once all the body modifications were made, the car was completely disassembled and painted inside with Por15. The engine bay and interior including the boot was painted gray, and black POR15 was put on all the other high rust areas.
Click the thumbnail to view image:
Por 15
Por 15
Sponsored Links. Did you know you can turn advertising off and support this site by upgrading to a Gold Membership?
Summary of Previous Journal Entries
Showing previous 10 journal entries:
| Title | Date | #Pic | #Cmt | Excerpt |
|---|---|---|---|---|
| Roll Bar Backing Plates | 2009-10-29 | 1 | One of the backing plates for the roll bar consisted of this angle iron to improve body stiffness. | |
| Roll Bar | 2009-10-29 | 1 | I know some don't like them but roll bars don't bother me aesthetically and this being a V8 conversion I wanted to try to add some stiffening to the body. All of the mounting point... | |
| Mazda Miata Seats | 2009-10-29 | 1 | Leather Mazda Miata seats were fitted. The original mounting points were used for the front bolts and two new holes were drilled for the rear. In addition, backing plates under the... | |
| Tramp Bars Mounting Points | 2009-10-29 | 1 | Glen Towery's mounting brackets were used for the tramp bars. The fine thread bolt allows precise adjustment of the tramp bars. I did not use a panhard rod. The tra... | |
| Tramp Bars | 2009-10-29 | 1 | To keep the stock MGB rear end located and put power to the ground adjustable tramp bars were made. Glen Towery's tramp bars were modified by cutting them, welding a nut on to the ... | |
| Header And More Stuff | 2009-10-29 | 1 | RV8 style headers were ceramic coated inside and out by Jet-Hot to increase longevity and decrease temperatures in the engine bay. Ceramic coating was expensive should pay for its ... | |
| Headers And Stuff | 2009-10-29 | 1 | A reinforcing ring was made from some sheet metal and a lot of manipulation with a hammer to strengthen the fender where the headers will pass through. | |
| AC Vents | 2009-10-28 | 1 | The low profile vents were purchased with the Superfrost kit. Round ones were also available. The low profile rectangular vents work nicely maintaining leg room. You... | |
| Position Of AC Dryer Etc. | 2009-10-28 | 1 | The dryer was located next to the radiator to minimize hoses running every where. And lets face it, there wasn't really any other place to put it. It is getting crowded in there. | |
| AC-4 | 2009-10-28 | 1 | Routing of AC hoses. Firewall connection obtained from Summit Racing. |
The contents of this journal entry (including entry images) are released
under the terms of the Creative Commons License unless otherwise noted.
under the terms of the Creative Commons License unless otherwise noted.
This page last modified May 09 2009 16:07:49 pm
Add a comment to this journal entry:
Please sign in if you already have an account or register now to enable this feature.