Journal: Wilbur Engelsma's Journal
 |
Visit Wilbur Engelsma's Profile for more information on this member. Subscribe to this Journal: 
What is RSS?
There are 49 entries in this Journal. Status: Silver Member  Location:  Broomfield, CO, USA |
|
Tail Lights
Created on 2008-07-20 19:22:06
The sheet metal around the tail lights didn't fit too well either- large gaps and the light frames don't sit flush to the body all around. After I filled and blended, the lights now fit much better.
Click the thumbnail to view image:
right light after modifications
left light after modification
tail lights installed
right light after modifications
left light after modification
tail lights installed
Sponsored Links. Did you know you can turn advertising off and support this site by upgrading to a Gold Membership?
Summary of Previous Journal Entries
Showing previous 10 journal entries:
| Title | Date | #Pic | #Cmt | Excerpt |
|---|---|---|---|---|
| Door Seams | 2008-07-06 | 6 | After all the body panels were installed and the doors hung, I measured the gaps around the doors. They varied from approximately 1/8" to 3/8", and the door skins weren't flush to ... | |
| Door Openings | 2008-07-02 | 5 | Since things are already getting out of hand welding up all the body seams, I thought I would seal up the gap between the front fender and the inner fender (at the front edge of th... | |
| Front Left Fender Completed | 2008-02-23 | 3 | Whoo-hoo! I finished blending in the front left fender this weekend, and primed it after finishing. Things are starting to come together! | |
| Fender Vents | 2008-02-12 | 6 | To keep the heat down in the engine compartment, I am installing vents in the fenders. I like the portholes (ventiports) from the 61 Buicks, and after much searching, I have enough... | |
| Right Front Fender | 2008-02-10 | 6 | Even though I didn't have to replace the whole right rocker panel, the front area had some damage that had to be patched prior to replacing the fender. The right fender needed repa... | |
| Left Front Fender | 2008-02-03 | 6 | Time to start on the front end bodywork. I have patch panels for both sides to replace the piece behind the front wheel from the chrome strip down. Plus the front corner where the ... | |
| Fuel Tank Mods Continued | 2008-01-12 | 9 | I didn't get to work on the car over Christmas, but since I got to spend time with kids home from college, that was OK. Now that everyone is back where they belong, and the world... | |
| Parking Brake | 2007-11-24 | 4 | 2 | I have never liked the location of the parking brake lever for three reasons: 1. The interference with the Fiero seats I am installing 2. The cable location in the tu... |
| Trunk Supports | 2007-11-22 | 3 | I installed a pair of hydraulic trunk supports to replace the existing trunk support. Like usual I didn't read the instructions first and installed (welded) the new one parallel to... | |
| Leaf Spring Hanger Braces | 2007-11-13 | 4 | The leaf spring hangers are just welded to the floor at the corners, so I thought I would reinforce them. This is not totally my idea- I found a similar installation for a 3 link s... |
The contents of this journal entry (including entry images) are released
under the terms of the Creative Commons License unless otherwise noted.
under the terms of the Creative Commons License unless otherwise noted.
This page last modified December 01 2007 20:50:32 pm
Add a comment to this journal entry:
Please sign in if you already have an account or register now to enable this feature.