Good and Bad Wire Wheel Hubs

Article written by Paul McLaren. Published on 2007-12-18
MG Experience Library – Service:Suspension and Wheels Section
The contents of this article are © Copyrighted and published under the following terms:
Released under the terms of the CC Attribution-NonCommercial-ShareAlike 2.5 License

I though the clunk in the rear end was caused by the thrust washers. It sure wasn't!

The wire wheel hubs were making all of the noise. Have attached a couple of photos of new hubs and badly worn.

Check yours today!

Old Worn Wire Wheel Splines

Brand New Wire Wheel Splines

Sponsored Links. You can hide this ad & support this site by upgrading to a Gold Membership ~ click here for more info.

~ Good and Bad Wire Wheel Hubs ~

Article by Paul McLaren – Published 2007-12-18

Did you find this article helpful? Rate or ask a question below!

Looking for car parts or other automotive products? — Visit the MG Experience Store

Return to the MG Experience – Service:Suspension and Wheels Library to read more great articles

Comments on "Good and Bad Wire Wheel Hubs"

Did you find this article useful?
Do you have a question or comment about the article above?
Leave a rating or a comment for the author here, and get instant reply notification via email!